open a (georeferenced) pdf map. Opening another replaces it.
locate shows your position as an orange dot. While you are moving, the status line also shows your true bearing and speed in mph. Tap locate again to turn off your position.
pins: with locate on, a pin shows distance and bearing from you. with locate off, you get two pins, and can read distance and true bearing from pin 1 to pin 2. Tap an existing pin to remove it.
follow keeps your location near the center of the screen. Dragging the map turns it off.
status: tap status line to change the size.
copy the current status line text.
calibrate is for pdfs with no georeferencing: zoom in and tap 3 known points spread in a wide triangle (e.g. corners). Enter each point's lat and lon (WGS84 decimal degrees, like 46.8868 and -102.788) in the two boxes above the buttons and press set. Only plain decimal numbers are accepted. Leave both boxes empty to use your GPS position for that point. Tap the map again to move the point, or press esc to drop it. Tap calibrate again to cancel.
iphone: allow location when asked, and keep Precise Location on (Settings > Privacy & Security > Location Services > Safari Websites). The screen stays awake while mapping. If the status line says sleepy, the screen could not be kept awake and may lock on its own; change Auto-Lock in Settings.
maps: usgs · forest service · t.rex arms · caltopo
supported: geopdf iso, lgi · projections utm/tm, ph, lcc, aea, merc, eqdc · datums wgs84, nad83, etrs89, gda94/2020 and sirgas 2000 (used as is, within about 2 m). Shifted to wgs84, roughly (a few m to ~20 m): nad27 (us, alaska, canada), ed50 (europe), osgb36 (great britain), agd66 (australia). A map in any other datum is used as if it were wgs84 and the status line says "datum unknown".
The ? button reopens this.